How do I do silicone sealant neatly? : so that's how it's done. now to retry my DIY botch job
GNU coreutils sort(1) now uses all available CPUs : using a parallel merge sort. great place to apply multicore code. very nice speedups: almost 4 times faster than single-core sort on a 8-core Xeon (via Padraig Brady)
REPLs suck, I want something block oriented : good opinion piece; I agree, REPL isn't a usable approach for block-oriented languages
languages repl programming ruby hacking coding block-oriented
#
I'm sorry, but I don't have the time and patience to read through countless responses, corrections, banter, and further questions to find out how to "do silicone sealant neatly". Could you provide a summary or at least link to the relevant comment?
Oh how I despise web forums. They're so slow and clumsy compared to NNTP and a nice news reader (Pine?). And they allow idiots to adorn each and every post with pointless, attention-grabbing signatures. Ugh...
/rant
let me see if I can summarise:
Q: 'After smoothing with a rounding tool (or a finger in a plastic bag) I always
end up with two lines of sealant either side of the joint where it has
overflowed from the rounding tool. Is there a technique or am I just using
too much sealant, or being to[o] impatient.'
A: 'Decide how big a bevel you want then cut the nozzle to around that size,
When you gun it in make sure you fill a little bit more than the size of
bevel you want thus not leaving any shallow parts. Then spray with water
using a squirty bottle with a fine mist( the water stop the silicone going
anywhere else apart from where you want it). Then tool off, us pro's use a
silicon tooling rubber block or the back of the tube with a good firm
continuous push.'
Others are saying to use a washing-up liquid and water solution instead of
just water, and to use masking tape either side to avoid overflow.
I did this job 2 days ago on our shower and used a kitchen knife dipped in sudsy water. It's not perfect but damn, looks good enough for me :)